草莓社区

1. Unplug your existing sump pump from wall outlet.
2. Plug your pump鈥檚 cord into the top outlet of the Sump Controller.
3. Plug the Piggyback Switch into the bottom outlet of the Sump Controller.
4. Plug the Pseudo Plug into the back of the Piggyback Switch.
5. Plug the included reed float switch wires into the side of the Sump Controller.
6. Plug the Sump Controller into the wall outlet.
7. Secure the High Level Switch to the discharge pipe with a cable tie. It should be located near the top of the sump pit.

1. From the Sump Controller, press and hold the MODE button for 4 to 15 seconds to enter the PAIRING MODE (blinking blue).
2. In the App, go to the 草莓社区 dashboard, then press ADD A DEVICE.
3. Select SUMP CONTROLLER. Click CONTINUE on both the INSTALLATION and the Bluetooth庐 wireless technology PAIRING screens.
4. Choose the device (name will always start with the letter PNR). The Bluetooth icon will turn white after connecting, so you know you鈥檝e made a successful connection.
5. Press CONTINUE on your phone when prompted.

1. Select your home WiFi account, add your home WiFi password and press CONTINUE.
2. Set the location of your Sump Controller. If you click on SELECT LOCATION, your current location should appear; select it and press SAVE. If not, manually enter the address. Press OK when prompted.
3. You are now connected!

1. Select your home WiFi account, add your home WiFi password and press CONTINUE.
2. Set the location of your Sump Controller. If you click on SELECT LOCATION, your current location should appear; select it and press SAVE. If not, manually enter the address. Press OK when prompted.
3. You are now connected!

Why is my pump not running when it鈥檚 supposed to be running?

• Float Switch Stuck in OFF Condition
• Relay fails in off condition
• Pump Not Plugged (Wire broken)
• Pump Plugged at wrong inlet
• 鈥淪eudo Plug鈥� not installed